FixVault
Home › Chevrolet › 2003 › SSR LS › Repair and Diagnosis › Restraints › Air Bag, SRS › Supplemental Inflatable Restraint System › Repair Instructions › Inflatable Restraint Side Impact Sensor Replacement › Removal Procedure

Removal Procedure

    CAUTION: Do not strike or jolt the inflatable restraint side impact sensor (SIS). Before applying power to the SIS make sure that it is securely fastened. Failure to observe the correct installation procedures could cause SIR deployment, personal injury, or unnecessary SIR system repairs.
    CAUTION: Refer to SIR CAUTION in Cautions and Notices.
  1. Disable the SIR system. Refer to SIR Disabling and Enabling Zone 2  and SIR Disabling and Enabling Zone 6 .
  2. Remove the front door trim panel. Refer to Trim Panel Replacement - Door in Doors.
  3. Peel the rear half of the water deflector away from the door in order to access the side impact sensor.
    4. Fig 1: Identifying Side Impact Sensor & Electrical Connector
    GM742146Courtesy of GENERAL MOTORS CORP.
  4. Remove the screws that retain the side impact sensor (2) to the door.
  5. Disconnect the impact sensor electrical connector (1) from the side impact sensor.
  6. Remove the side impact sensor from the door.
About FixVault