FixVault
Home › Chevrolet › 2003 › Venture Base, Van Cargo Extended › Repair and Diagnosis › Accessories & Equipment › Wiper/Washer Systems › Wiper System And Washer System › Repair Instructions › Wiper Module Cover Replacement › Installation Procedure

Installation Procedure

  1. Position the wiper drive system module cover to the pinchweld flange.
  2. Install the wiper drive system module cover to the pinchweld flange, pressing down until fully seated.
  3. Install the hood rear seal to the pinchweld flange.
  4. Close the hood.
    Fig 1: Installing Wiper Drive System Module Cover To Pinchweld Flange
    G01534205Courtesy of GENERAL MOTORS CORP.
About FixVault