Installation Procedure

NOTE: Refer to FASTENER NOTICE in Cautions and Notices.

Connect the starter motor field leads to the starter motor as follows:
1. Loosely install the starter enable relay lead (1) to the starter solenoid terminal.
  Align the terminal retaining tab to the starter solenoid.
2. Loosely install generator output (BAT) lead (3) and the battery positive cable (2) to the solenoid terminal.
  Align the battery positive cable terminal retaining tab to the starter solenoid.
  
  Tighten:
  - Tighten the starter enable relay lead nut to 2 N.m (18 lb in).
  - Tighten the battery positive cable nut to 9 N.m (80 lb in).
  Fig 1: Expanded View Of Starter Motor Leads
  Courtesy of GENERAL MOTORS CORP.
Install the two starter motor mounting bolts and the shims (if necessary) through the starter to the engine.
Tighten: Tighten the bolts to 43 N.m (32 lb ft).

Fig 2: Locating Starter Motor Mounting Bolts
Courtesy of GENERAL MOTORS CORP.
Lower the vehicle.
Connect the battery negative cable.