FixVault
Home › Chevrolet › 2004 › Chevy Express H1500, Van Passenger › Repair and Diagnosis › Accessories & Equipment › Entertainment Systems › Cellular Communication System › Repair Instructions › Bracket Assembly Replacement - OnStar Module › Installation Procedure

Installation Procedure

  1. Slide the module (3) into the mounting bracket (1).
    2. Fig 1: Sliding Module Into Mounting Bracket
    GM871219Courtesy of GENERAL MOTORS CORP.
  2. Push the module (3) towards the mounting bracket (1) at the end near the tab (2). Push until the module (3) is seated in the mounting bracket (1).
  3. Install the module and bracket (2) to the I/P.
    4. Fig 2: Installing Module & Bracket To I/P
    GM871220Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the bolts (3).

    Tighten:  Tighten the bolts (3) to 3 N.m (27 lb in).

  5. Connect the coaxial cable and the electrical connectors (2) to the module.
  6. Install the drivers knee bolster. Refer to Knee Bolster Replacement - Left in Instrument Panel, Gages, and Console.
About FixVault