FixVault
Home › Chevrolet › 2004 › Corvette Base, 2D Convertible, Automatic › Repair and Diagnosis › Electrical › Instrument Panel System Displays, Gauges And Console › Repair Instructions › Console Replacement › Installation Procedure

Installation Procedure

    Fig 1: Electrical Connector At Fuel Door Release
    GM95713Courtesy of GENERAL MOTORS CORP.
  1. Install the fuel door release, rear lift window release (export) switch to the console.

    Align the switch, then push to secure.

  2. Connect the electrical connector to the switch.
    3. Fig 2: Electrical Connector At Electrical Accessory Plug
    GM95719Courtesy of GENERAL MOTORS CORP.
  3. Install the electrical accessory plug housing to the console.

    Check that the cover plug is in place on the accessory plug housing.

  4. Install the electrical accessory plug retainer onto the accessory plug housing.

    Screw the retainer onto the housing until secure.

  5. Connect the electrical connector to the electrical accessory plug.
    6. Fig 3: Console Under Rear Of IP Accessory Trim Plate
    GM95703Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Be sure to install the front of the console UNDER the rear of the IP accessory trim plate.
  6. Install the console into position.

    Insert the front of the console under the rear of the IP accessory trim plate.

  7. Loosely install the console retaining nuts.
    8. NOTE: Refer to Fastener Notice in Cautions and Notices.
  8. Position the console to the IP accessory trim plate (at the front) and the floor extension carpet (at the rear) for best appearance.

    Tighten:  Tighten the console retaining nuts to 10 N.m (89 lb in).

    9. Fig 4: Electrical Connector To Electronic Traction Control
    GM631175Courtesy of GENERAL MOTORS CORP.
  9. Connect the electrical connector (1) to the electronic traction control, ride control switch.
    10. Fig 5: Led Connector To Wiring Harness Connector
    GM631216Courtesy of GENERAL MOTORS CORP.
  10. Connect the LED connector (1) to the wiring harness connector (2).
  11. Insert the electronic traction control, ride control switch front retaining tab under the edge of the IP accessory trim plate.
  12. Lower the rear of the switch into position, then push to secure the retaining clips.
  13. Close the console door.
  14. Install the folding top stowage compartment lid extension panel (convertible). Refer to Compartment Lid Extension - Folding Top Stowage in Interior Trim.
About FixVault