FixVault
Home › Chevrolet › 2004 › Corvette Base, 2D Convertible, Automatic › Repair and Diagnosis › Electrical › Instrument Panel System Displays, Gauges And Console › Repair Instructions › Head Up Display Switch Replacement › Installation Procedure

Installation Procedure

    Fig 1: IP Dimmer/HUD Switch To IP Cluster Bezel
    GM95722Courtesy of GENERAL MOTORS CORP.
  1. Install the IP dimmer/HUD switch to the IP cluster bezel.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the IP dimmer/HUD switch retaining screws.

    Tighten:  Tighten the IP dimmer/HUD switch retaining screws to 1.5 N.m (13 lb in).

    3. Fig 2: IP Cluster Bezel To IPC
    GM95724Courtesy of GENERAL MOTORS CORP.
  3. Install the bezel to the IPC.

    Align the bezel onto the guide pins.

  4. Install the IP cluster bezel retaining screws.

    Tighten:  Tighten the instrument panel cluster bezel retaining screws to 1.5 N.m (13 lb in).

    5. Fig 3: Instrument Panel Dimmer/HUD Switch Electrical Connector
    GM95725Courtesy of GENERAL MOTORS CORP.
  5. Connect the IP dimmer/HUD switch electrical connector.
    6. Fig 4: Driver Information Center (DIC) Switch Electrical Connector
    GM95726Courtesy of GENERAL MOTORS CORP.
  6. Connect the DIC switch electrical connector.
  7. Install the IPC to the vehicle. Refer to Instrument Panel Cluster (IPC) Replacement .
About FixVault