Removal Procedure

Fig 1: SIR System, Upper & Lower Trim Covers

Courtesy of GENERAL MOTORS CORP.

CAUTION: Refer to SIR Caution in Cautions and Notices.

Disable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in SIR.
Remove the upper and lower trim covers. Refer to Steering Column Trim Covers Replacement (Telescoping) or Steering Column Trim Covers Replacement (Manual) .
Tilt the column in the UP position.

Fig 2: Removing Tilt Spring From Steering Column Support Assembly

Courtesy of GENERAL MOTORS CORP.

CAUTION: The tilt spring and the spring guide are under pressure. The tilt spring and the spring guide may become a projectile. Secure the spring with locking pliers during removal. Secure the spring with locking pliers during installation. Bodily injury may result during removal and installation of the tilt spring and the spring guide. Always use caution during removal and installation of the tilt spring and the spring guide.

Perform the following steps to remove the tilt spring (1):
1. Pry the tilt spring (1) up with a screwdriver until a bulge occurs. The spring tension is mostly removed.
2. Secure the tilt spring (1) with locking pliers.
3. Continue to pry until the tilt spring (1) disengages from the post on the steering column support (2) and the steering column tilt head assembly (3).

Fig 3: Spring Guide & Tilt Spring

Courtesy of GENERAL MOTORS CORP.

Remove the spring guide from the tilt spring.