FixVault
Home › Chevrolet › 2004 › Cutaway 6.0 U › Repair and Diagnosis (Single Page) › Accessories & Equipment › Communication Devices › Body Control System › Repair Instructions › Body Control Module Replacement › Removal Procedure

Removal Procedure

  1. Remove the right side knee bolster trim panel. Refer to Knee Bolster Replacement - Right in Instrument Panel, Gages, and Console.
    2. Fig 1: Removing Right Side Knee Bolster Trim Panel
    GM853308Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the electrical connectors (2) from the Body Control Module (BCM) (1).
    3. Fig 2: Disconnecting Electrical Connectors From Body Control Module
    GM923655Courtesy of GENERAL MOTORS CORP.
  3. Release the tabs (2) retaining the BCM (1) to the bracket.
    4. Fig 3: Releasing Tabs Retaining BCM To Bracket
    GM923653Courtesy of GENERAL MOTORS CORP.
  4. Remove the BCM (1) from the vehicle.
About FixVault