FixVault
Home › Chevrolet › 2004 › Epica LS › Repair and Diagnosis › Steering › Steering Wheel & Steering Column › Repair Instructions › Multifunction, Turn Signal Switch Replacement › Installation Procedure

Installation Procedure

    Fig 1: Identifying Turn Signal Switch Tabs
    GM1255838Courtesy of GENERAL MOTORS CORP.
  1. Connect the electrical connections to the turn signal switch.
  2. Install the turn signal switch by snapping it into the switch housing.
    3. Fig 2: View Of Steering Column Cover Panel And Screws
    GM1255836Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the upper and the lower steering column cover panels. Install the upper and the lower steering column cover panel screws.

    Tighten:  Tighten the upper and the lower steering column cover panel screws to 2.5 N.m (22 lb in)  .

  4. Connect the negative battery cable.
About FixVault