FixVault
Home › Chevrolet › 2004 › Impala Base, 3.4 E › Repair and Diagnosis › Engine Performance › System › Engine Control System 3.4L (Introduction) › Repair Instructions › Exhaust Gas Recirculation (EGR) Valve Replacement › Installation Procedure

Installation Procedure

  1. Install a new EGR valve gasket.
  2. Install the EGR valve.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the EGR valve bolts.

    Tighten:  Tighten the bolt to 30 N.m (22 lb ft).

  4. Install the EGR pipe to the EGR valve.
  5. Install the EGR pipe.

    Tighten:  Tighten the bolt to 25 N.m (18 lb ft).

  6. Connect the EGR valve electrical connector.
    7. Fig 1: Installing EGR Valve
    GM507392Courtesy of GENERAL MOTORS CORP.
About FixVault