Removal Procedure
- Remove the rear quarter upper trim. Refer to Trim Panel Replacement - Rear Quarter Upper (Impala) or Trim Panel Replacement - Rear Quarter Upper (Monte Carlo) in Interior Trim.
- Remove the rear quarter lower trim. Refer toTrim Panel Replacement - Rear Quarter Lower (Impala) or Trim Panel Replacement - Rear Quarter Lower (Monte Carlo) in Interior Trim.
- This will allow the urethane adhesive to be separated from the window.
- Leave a base of urethane on the pinch-weld flange.
- The only suitable lubrication is clear water.
- Use J 39032 (see Special Tools ) or equivalent in order to remove the window.
- Remove the quarter modular window from the pinch-weld flange.
CAUTION:
If a window is cracked but still intact, crisscross the window with masking tape in order to reduce the risk of damage or personal injury.
IMPORTANT:
Before cutting out a stationary window, apply a double layer of masking tape around the perimeter of the painted surfaces and inner trim of the window.
CAUTION:
Refer to Glass and Sheet Metal Handling Caution in Cautions and Notices.
IMPORTANT:
Keep the cutting edge of the tool against the window. Do this from inside the vehicle to protect the outer painted surface.