FixVault
Home › Chevrolet › 2004 › Impala LS › Repair and Diagnosis › Engine Performance › System › Engine Control System 3.8L (Introduction) › Repair Instructions › Fuel Tank Pressure Sensor Replacement › Installation Procedure

Installation Procedure

  1. Install the new fuel tank pressure sensor (7) to the fuel sender assembly (1).
  2. Install the fuel sender assembly. Refer to Fuel Sender Assembly Replacement .
  3. Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
    4. Fig 1: Fuel Pump & Sender Assembly Component View
    GM50636Courtesy of GENERAL MOTORS CORP.
About FixVault