FixVault
Home › Chevrolet › 2004 › Impala LS › Repair and Diagnosis › External Pages › Different car › Section 102 (Wiper System & Washer System) › Repair Instructions › Washer Solvent Container Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Buick LaCrosse and 2005 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Upper Washer Solvent Container Screw
    GM1257439Courtesy of GENERAL MOTORS CORP.
  1. Position the washer solvent container to the right frame rail.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the lower washer solvent container screws.

    Tighten:  Tighten the screws to 10 N.m (89 lb in).

    3. Fig 2: Identifying Washer Pump Hose, Washer Pump Electrical Connector, & Washer Solvent Level Sensor
    GM815208Courtesy of GENERAL MOTORS CORP.
  3. Install the washer pump to the container.
  4. Install the level sensor to the container.
  5. Connect the washer solvent level sensor electrical connector.
  6. Connect the washer pump electrical connector.
  7. Connect the washer pump hose.
  8. Install the right front fender liner. Refer to Fender, Fender Insulator, Wheelhouse Liner Replacement - Front in Body Front End.
    9. Fig 3: Upper Washer Solvent Container Screw
    GM1257439Courtesy of GENERAL MOTORS CORP.
  9. Install the upper washer solvent container screw.

    Tighten:  Tighten the screw to 10 N.m (89 lb in).

  10. Fill the washer solvent container with washer solvent.
  11. Close the hood.
About FixVault