FixVault
Home › Chevrolet › 2004 › Impala LS › Repair and Diagnosis › External Pages › Different car › Section 1090 (Wiper System And Washer System) › Repair Instructions › Windshield Washer Solvent Level Indicator Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2012 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Disconnecting Washer Solvent Container Level Sensor Electrical Connector
    GM1207514Courtesy of GENERAL MOTORS COMPANY
  1. Position the level indicator seal (3) to the washer solvent container (1), pressing in until fully seated.
  2. Using full strength windshield washer solvent on the seal, position the washer solvent level indicator (4) to the washer solvent container (1), pressing in until fully seated.
  3. Connect the washer solvent level indicator electrical connector.
  4. Install the front wheelhouse panel splash shield. Refer to Front Wheelhouse Panel Splash Shield Replacement .
  5. Fill the washer solvent container with windshield washer solvent.
About FixVault