Fastener Tightening Specifications

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.

Application	Specification
Application	Metric	English
Ball Stud Castle Nut-Lower Control Arm	55 N.m	40 lb ft
Ball Stud Nuts-Replacement Ball Joint¹	68 N.m	50 lb ft
Lower Control Arm Nuts-at Frame¹	113 N.m	83 lb ft
Stabilizer Shaft Insulator Bracket Bolts	48 N.m	35 lb ft
Stabilizer Shaft Link Nut	23 N.m	17 lb ft
Strut Lower Nuts-at Knuckle¹	123 N.m	90 lb ft
Strut Shaft Nut ¹	85 N.m	63 lb ft
Strut Upper Nuts	41 N.m	30 lb ft
Wheel Bearing/Hub Bolts-NEW ONLY	130 N.m	96 lb ft
¹ This is a prevailing torque type fastener. This fastener may be reused ONLY if: The fastener and its counterpart are clean and free from rust. The fastener develops a specified amount of torque (drag) against its counterpart prior to the fastener seating Refer to the appropriate service procedure for the prevailing torque value. If the fastener does not meet these criteria, REPLACE the fastener.