FixVault
Home › Chevrolet › 2004 › Impala LS › Repair and Diagnosis › External Pages › Different car › Section 619 (Theft Deterrent System) › Repair Instructions › Theft Deterrent Module Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Buick Lucerne. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Theft Deterrent Module & Ignition Lock Cylinder Case Assembly
    GM324869Courtesy of GENERAL MOTORS CORP.
  1. Install the theft deterrent control module (2) onto the ignition lock cylinder case assembly (1).
    2. CAUTION: Refer to SIR INFLATOR MODULE COIL CAUTION .
  2. Connect the connector to the theft deterrent control module.
  3. If necessary, connect the connector to the ignition lock cylinder case.
  4. Install the lock cylinder. Refer to Ignition Lock Cylinder Replacement .
  5. Install the upper and lower trim covers. Refer to Steering Column Trim Covers Replacement .
  6. Enable the SIR system. Refer to SIR Disabling and Enabling .
  7. Programming the immobilizer system components. Refer to Programming Immobilizer System Components .
  8. Refer to Control Module References for programming and setup information.
About FixVault