FixVault
Home › Chevrolet › 2004 › Impala LS › Repair and Diagnosis › External Pages › Different variant/trim › Section 2 (Engine Control System 3.4L (Introduction)) › Repair Instructions › Fuel Tank Pressure Sensor Replacement › Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the fuel sender assembly. Refer to Fuel Sender Assembly Replacement .
  2. Remove the fuel tank pressure sensor (7) from the fuel sender assembly.
    3. Fig 1: Fuel Pump & Sender Assembly Component View
    GM50636Courtesy of GENERAL MOTORS CORP.
About FixVault