FixVault
Home › Chevrolet › 2004 › Impala LS › Repair and Diagnosis › Transmission › Automatic Trans › Automatic Transaxle - 4T65-E (Introduction, Service & Replacement) › Repair Instructions › Floor Shift Control Replacement › Installation Procedure

Installation Procedure

  1. Install the console shift control into the vehicle.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices
  2. Install the console shift control retaining nuts.

    Tighten:  Tighten the console shift control retaining nuts to 24 N.m (18 lb ft).

    3. Fig 1: Console Shift Control Assembly
    GM161200Courtesy of GENERAL MOTORS CORP.
  3. Install the park/lock cable. Refer to Park Lock Cable Replacement .
  4. Install the automatic transaxle range selector cable. Refer to Automatic Transmission Range Selector Cable Replacement .
  5. Install the console shift control wiring harness.
  6. Install the console wiring harness.
    7. Fig 2: Installing Console Shift Control Wiring Harness
    GM161196Courtesy of GENERAL MOTORS CORP.
  7. Install the console trim plate. Refer to Trim Plate Replacement - Front Floor Console (Monte Carlo) or Trim Plate Replacement - Front Floor Console (Impala) or Console Replacement - Front Floor (Impala) or Console Replacement - Front Floor (Monte Carlo) in Instrument Panel, Gauges and Console.
About FixVault