FixVault
Home › Chevrolet › 2004 › Impala Police › Repair and Diagnosis › Engine Performance › System › Engine Control System 3.8L (Introduction) › Repair Instructions › Idle Air Control (IAC) Valve Replacement › Removal Procedure

Removal Procedure

  1. Remove the fuel injector sight shield. Refer toFuel Injector Sight Shield Replacement in Engine Mechanical-3.8L.
  2. Disconnect the idle air control valve (IAC) electrical connector.
    3. Fig 1: View Of IAC Valve Electrical Connector
    GM155466Courtesy of GENERAL MOTORS CORP.
  3. Remove the IAC valve screws.
    4. Fig 2: Removing IAC Valve Screws
    GM185614Courtesy of GENERAL MOTORS CORP.
  4. Remove the IAC valve.
    5. Fig 3: Removing IAC Valve
    GM185583Courtesy of GENERAL MOTORS CORP.
  5. Remove the IAC valve O-ring.
    6. Fig 4: Removing IAC Valve O-Ring
    GM185626Courtesy of GENERAL MOTORS CORP.
About FixVault