Installation Procedure

Install the power seat switch to the front seat cushion trim panel, if equipped. Refer to Seat Switch Replacement - Power .
Install the lumbar control switch to the front seat cushion trim panel, if equipped. Refer to Lumbar Switch Replacement .
Install the heated seat switch to the front seat cushion trim panel, if equipped. Refer to Heated Seat Switch Replacement - Front (Impala) or Heated Seat Switch Replacement - Front (Monte Carlo) .
Install the seat cushion trim panel, pressing in until the two retaining clips are fully seated.

Fig 1: Installing Recliner Handle Hole Retaining Clips

GM522216

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the front cushion trim panel rear screws.
Tighten: Tighten the front seat cushion trim panel screws to 3 N.m (27 lb in).

Fig 2: Installing Front Cushion Trim Panel Rear Screws

GM522222

Courtesy of GENERAL MOTORS CORP.

Install the push-in retainer to the front of the front seat cushion trim panel, pressing into place until fully seated.

Fig 3: Installing Front Seat Cushion Trim Panel Push-In Retainer

GM522223

Courtesy of GENERAL MOTORS CORP.

Install the front seat lumbar knob, pressing into place until fully seated.

Fig 4: Front Seat Lumbar Knob

GM522225

Courtesy of GENERAL MOTORS CORP.

Install the front seat back recliner handle, pressing into place until fully seated.

Fig 5: Installing Front Seat Back Recliner Handle

GM522228

Courtesy of GENERAL MOTORS CORP.