Installation Procedure

WARNING: This page is about a different car, the 2007 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Blower Motor Resistor

Courtesy of GENERAL MOTORS CORP.

Install the blower motor control processor.

NOTE: Refer to Fastener Notice .

Tighten the blower motor control processor screws.
Tighten: Tighten the blower motor resistor screws to 1.5 N.m (13 lb in).
Install the blower motor control processor wire harness connector.
Install the right closeout panel. Refer to Instrument Panel Insulator Panel Replacement - Right Side .