FixVault
Home › Chevrolet › 2004 › Impala SS › Repair and Diagnosis › Restraints › Restraints Control Systems › Seat Belt System › Repair Instructions › Bracket Replacement - Child Seat Belt Restraint System › Installation Procedure

Installation Procedure

  1. Position the bracket in the vehicle.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Apply a thread sealant, GM P/N 12345382 (Canada 10953489,) Loctite 242, Permatex 24200 to the threads of the bolts (2).
  3. Install the bolts (2) to each end of the bracket.

    Tighten:  Tighten the child seat latch bracket bolts to 42 N.m (31 lb ft).

  4. Install the bracket nut (1) between the center seat belts.

    Tighten:  Tighten the child seat latch bracket nut to 42 N.m (31 lb ft).

    5. Fig 1: Installing Bracket Nuts & Bolts
    GM782304Courtesy of GENERAL MOTORS CORP.
  5. Install the rear center seat belts. Refer to Seat Belt Replacement - Center Rear .
  6. Install the rear seat back. Refer to Seat Back Replacement - Rear (Fixed) or Seat Back Replacement - Rear (Folding) in Seats.
About FixVault