FixVault
Home › Chevrolet › 2004 › Malibu Maxx › Repair and Diagnosis › Engine Performance › System › Engine Control System (Introduction) - 3.5L (Lx9) › Repair Instructions › Camshaft Position (CMP) Sensor Replacement › Removal Procedure

Removal Procedure

  1. Disconnect the camshaft position (CMP) sensor electrical connector.
  2. Remove the CMP sensor bolt.
    3. Fig 1: View Of Camshaft Position Sensor
    GM909619Courtesy of GENERAL MOTORS CORP.
  3. Remove the CMP sensor.
  4. Inspect the sensor O-ring for wear, cracks, or leakage if the sensor is not being replaced.
About FixVault