FixVault
Home › Chevrolet › 2004 › Malibu Maxx › Repair and Diagnosis › External Pages › Different variant/trim › Section 1 (Engine Control System (Introduction) - 2.2L (L61)) › Repair Instructions › Accelerator Controls Pedal Replacement › Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Disconnecting Accelerator Pedal Position Sensor Electrical Connector
    GM1544734Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the accelerator pedal position sensor electrical connector.
  2. Remove the accelerator mounting bolts (1) from the accelerator bracket.
  3. Remove the accelerator assembly (2) from the vehicle.
About FixVault