FixVault
Home › Chevrolet › 2004 › Monte Carlo LS › Repair and Diagnosis › Engine Performance › System › Engine Control System 3.4L (Introduction) › Repair Instructions › Crankshaft Position (CKP) Sensor Replacement (24X) › Installation Procedure

Installation Procedure

  1. Install the CKP sensor (1).
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the CKP sensor bolts (4).

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

  3. Install the CKP sensor harness retaining clip (3).
  4. Install the CKP sensor harness retaining clip bolt (4).

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

  5. Connect the CKP sensor electrical connector.
  6. Install the crankshaft balancer. Refer to Crankshaft Balancer Replacement in Engine Mechanical - 3.4L.
  7. Perform the crankshaft variation learn procedure. Refer to CKP System Variation Learn Procedure .
    8. Fig 1: Installing CKP Sensor (24X)
    GM14714Courtesy of GENERAL MOTORS CORP.
About FixVault