Installation Procedure
CAUTION:
Refer to Gasoline/Gasoline Vapors Caution and Fuel Gage Leak Caution in Cautions and Notices.
NOTE:
Clean all of the following areas before performing any disconnections in order to avoid possible contamination in the system:
- The fuel pipe connections
- The hose connections
- The areas surrounding the connections
IMPORTANT:
Position the fuel pressure gage fitting to avoid contact with the belt.
- Install J 34730-1A with.J 34730-262 to the fuel pressure service connection, located on the fuel rail.
- Turn ON the ignition.
- Place the bleed hose of the fuel pressure gage into an approved gasoline container.
- Open the bleed valve on the fuel pressure gage in order to bleed the air from the fuel pressure gage.
- Command the fuel pump ON with a scan tool until all of the air is bled out of the gage.
- Close the bleed valve on the fuel pressure gage.
- Command the fuel pump ON with a scan tool.
- Inspect for fuel leaks.
CAUTION:
Refer to Fuel Storage Caution in Cautions and Notices.