FixVault
Home › Chevrolet › 2004 › Monte Carlo LS › Repair and Diagnosis › Engine Performance › System › Engine Control System 3.4L (Introduction) › Repair Instructions › Manifold Absolute Pressure (MAP) Sensor Replacement › Installation Procedure

Installation Procedure

  1. Position the MAP sensor to the bracket.
  2. Install the inlet vacuum hose to the MAP sensor.
  3. Connect the MAP sensor electrical connector.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the MAP sensor screws.

    Tighten:  Tighten the screws to 3 N.m (27 lb in).

    5. Fig 1: Removing MAP Sensor
    GM54360Courtesy of GENERAL MOTORS CORP.
About FixVault