FixVault
Home › Chevrolet › 2004 › Optra Base, Automatic › Repair and Diagnosis › Steering › Power Steering System › Repair Instructions › Steering Linkage Outer Tie Rod Replacement › Installation Procedure

Installation Procedure

    Fig 1: View Of Outer And Inner Tie Rod
    GM1290111Courtesy of GENERAL MOTORS CORP.
  1. Reposition the adjusting nut to the marks on the inner tie rod.
  2. Install the outer tie rod by twisting it onto the inner tie rod.
    3. Fig 2: View Of Outer Tie Rod And Steering Knuckle
    GM1290872Courtesy of GENERAL MOTORS CORP.
  3. Connect the outer tie rod to the steering knuckle.
  4. Perform a front toe adjustment. Refer to Wheel Alignment - Steering Wheel Angle and/or Front Toe Adjustment .
    5. NOTE: Refer to Fastener Notice .
  5. Install the adjusting nut.

    Tighten:  Tighten the outer adjusting nut to 64 N.m (47 lb ft)  .

  6. Install the outer tie rod nut.

    Tighten:  Tighten the outer tie rod nut to 50 N.m (37 lb ft)  .

  7. Install the wheel. Refer to Tire and Wheel Removal and Installation .
About FixVault