FixVault
Home › Chevrolet › 2004 › Optra Base, Standard › Repair and Diagnosis › Transmission › Manual Trans › Manual Transmission - D20 › Repair Instructions › Shift Control Linkage Replacement › Removal Procedure

Removal Procedure

    Fig 1: View Of Universal Joint, Clip And Bolt
    GM1248177Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.
  1. Disconnect the negative battery cable.
  2. Remove the rod clamp. Refer to Shift Linkage Adjustment .
  3. Remove the clip and the bolt from universal joint.
  4. Separate the universal joint from the transaxle.
    5. Fig 2: View Of Transaxle Rear Mounting Bracket And Fixing Shaft Pin
    GM1248179Courtesy of GENERAL MOTORS CORP.
  5. Remove the fixing shaft pin and separate the linkage connection part from the transaxle rear mounting bracket.
  6. Remove the shift linkage assembly.
About FixVault