FixVault
Home › Chevrolet › 2004 › SSR › Repair and Diagnosis › Body & Frame › Sun Roof/T-Top/Convertible Top › Sunroof System › Repair Instructions › Folding Top Control Module Replacement › Installation Procedure

Installation Procedure

    Fig 1: View of Control Module
    GM1302509Courtesy of GENERAL MOTORS CORP.
  1. Install the folding top control module into the vehicle.
    2. Fig 2: Identifying Electrical Connectors
    GM1302510Courtesy of GENERAL MOTORS CORP.
  2. Connect the electrical connectors to the control module.
    3. Fig 3: View of Control Module Clips
    GM1302507Courtesy of GENERAL MOTORS CORP.
  3. Push down firmly on the control module to seat the folding top control module clip into the body rear compartment.
    4. Fig 4: View of Body Rear Compartment Lid
    GM1302497Courtesy of GENERAL MOTORS CORP.
  4. Install the body rear compartment lid.
    5. Fig 5: Identjfying Body Rear Compartment Lid Fasteners
    GM1302294Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Install the body rear compartment lid fasteners.

    Tighten:  Tighten the body rear compartment lid fasteners to 2 N.m (18 lb in).

    6. Fig 6: View of Body Rear Compartment Lid Latches
    GM1302490Courtesy of GENERAL MOTORS CORP.
  6. Latch the body rear compartment lid latches.
  7. Remove the protective coverings from the vehicle.
  8. Connect the battery. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
    9. IMPORTANT: The window cycle learn procedure must be performed or the folding top will not operate correctly.
  9. Perform the window cycle learn procedure. Refer to Reinitialization of the Power Window in Doors.
  10. Connect the Tech-2 and reset any diagnostic codes that may be present.
  11. Cycle the folding top under power through one complete cycle in both directions.
  12. Inspect the folding top for proper operation. Refer to Power Folding Top Description and Operation .
About FixVault