FixVault
Home › Chevrolet › 2004 › SSR › Repair and Diagnosis › Electrical › Body Electrical › Wiring Systems - Introduction › Repair Instructions › Rear Electrical Center or Junction Block Replacement › Removal Procedure

Removal Procedure

    Fig 1: View of Folding Top
    GM1362522Courtesy of GENERAL MOTORS CORP.
  1. Cycle the folding top to reveal the body accessory compartment.
  2. Turn the ignition switch to the OFF position.
  3. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
    4. Fig 2: View of Body Accessory Compartment
    GM1386454Courtesy of GENERAL MOTORS CORP.
  4. Loosen the nuts and remove the lid from the body accessory compartment.
  5. Remove the folding top control module. Refer to Folding Top Control Module Replacement .
    6. Fig 3: Identifying Rear Electrical Center Retaining Tab
    GM1390816Courtesy of GENERAL MOTORS CORP.
  6. Depress the retaining tab (1) and remove the rear electrical center from the intermediate bracket.
  7. Disconnect the electrical connector from the rear electrical center.
  8. Remove the rear electrical center for the vehicle.
About FixVault