FixVault
Home › Chevrolet › 2004 › SSR › Repair and Diagnosis › External Pages › Different car › Section 424 (Battery, Charging System And Starting System) › Repair Instructions › Generator Cable Replacement › Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2004 GMC Yukon XL, 2004 GMC Yukon, 2004 Chevrolet Tahoe, 2004 Chevrolet Suburban, and 2004 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Battery Cables At Junction Block
    GM662521Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the generator cable (2) to the junction block.
  2. Install the generator cable nut.

    Tighten:  Tighten the nut to 9 N.m (80 lb in).

  3. Close the positive cable junction block.
    4. Fig 2: View Of Generator Cable & Nut
    GM395686Courtesy of GENERAL MOTORS CORP.
  4. Install the generator cable to the generator, perform the following:
    1. Install the generator cable to the stud.
    2. Install the generator cable nut.

      Tighten:  Tighten the nut to 9 N.m (80 lb in).

    3. Position the boot to cover the stud.
  5. If necessary, install the engine sight shield. Refer to Engine Sight Shield Replacement (4.8L, 5.3L, and 6.0L (RPO LQ4)) or Engine Sight Shield Replacement (6.0L (RPO LQ9)) in Engine Mechanical - 4.8L, 5.3L, and 6.0L, or Engine Sight Shield Replacement in Engine Mechanical - 8.1L.
  6. Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure .
About FixVault