FixVault
Home › Chevrolet › 2004 › SSR › Repair and Diagnosis › External Pages › Different car › Section 440 (Antilock Brake System, Traction Control System & Stability Control System) › Repair Instructions › Wheel Speed Sensor Ring Replacement - Rear › Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2004 GMC Yukon XL, 2004 GMC Yukon, 2004 Chevrolet Tahoe, 2004 Chevrolet Suburban, and 2004 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  3. Remove the rear wheel speed sensor. Refer to Wheel Speed Sensor Replacement - Rear .
  4. Remove the rear axle housing cover. Refer to Rear Axle Housing Cover and Gasket Replacement in Rear Drive Axle.
  5. Remove the axle shaft. Refer to Rear Axle Shaft Replacement (8.6 Inch Axle W/O JL4, 9.5 Inch Axle) or Rear Axle Shaft Replacement (8.6 Inch Axle W/JL4) or Rear Axle Shaft Replacement (9.75 Inch Axle) in Rear Drive Axle.
  6. Remove the axle shaft seal and the bearing from the axle housing using the J 44685  (1) and the J 2619-01  (2).
  7. Remove the wheel speed sensor ring from the axle housing using the J 45857  (1) and the J 2619-01  (2).
    8. Fig 1: Removing The Wheel Speed Sensor Ring From The Axle Housing
    GM889095Courtesy of GENERAL MOTORS CORP.
About FixVault