FixVault
Home › Chevrolet › 2004 › SSR › Repair and Diagnosis › External Pages › Different car › Section 461 (Rear Wheel Steering System) › Repair Instructions › Rear Wheel Steering Control Module Bracket Replacement › Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2004 GMC Yukon XL, 2004 GMC Yukon, 2004 Chevrolet Tahoe, 2004 Chevrolet Suburban, and 2004 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Rear Wheel Steering Control Module & Bracket
    GM865336Courtesy of GENERAL MOTORS CORP.
  1. Install the bracket to the vehicle.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the bracket retaining nuts.

    Tighten:  Tighten the retaining nuts to 25 N.m (18 lb ft).

  3. Install the rear wheel steering control module (2) o the bracket. Refer to Rear Wheel Steering Control Module Replacement .
  4. Perform a learn alignment. Refer to Measuring Wheel Alignment (w/Rear Wheel Steering) or Measuring Wheel Alignment (w/o Rear Wheel Steering) in Wheel Alignment.
About FixVault