FixVault
Home › Chevrolet › 2004 › SSR › Repair and Diagnosis › External Pages › Different car › Section 465 (Body Front End) › Repair Instructions › Hood Latch Replacement › Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2004 GMC Yukon XL, 2004 GMC Yukon, 2004 Chevrolet Tahoe, 2004 Chevrolet Suburban, and 2004 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the hood release cable end to the latch.
  2. Connect the hood ajar indicator switch connector, if equipped.
    3. Fig 1: Connecting Hood Release Cable End To Latch
    GM393503Courtesy of GENERAL MOTORS CORP.
  3. Install the hood latch (1) to the radiator support (3).
  4. Install the hood latch bolts (2) loosely.
    5. Fig 2: Installing Hood Latch & Bolts
    GM331323Courtesy of GENERAL MOTORS CORP.
  5. Adjust the hood latch height so that when the hood is closed, the hood is held securely against the front hood bumpers.
    6. NOTE: Refer to Fastener Notice in Cautions and Notices.
  6. Raise the hood.

    Tighten:  Tighten the hood latch bolts to 9 N.m (80 lb in).

  7. Adjust the front hood bumpers so that the top of the hood is flush with the fenders.
  8. Install the upper radiator support baffle. Refer to Radiator Air Baffle and Deflector Replacement - Upper .
About FixVault