Connect Procedure

WARNING: This page is about a different car, the 2003 Chevrolet SSR. However, it is still accessible from the selected car via links, so may be relevant.

Verify that all electrical components are off such as interior lights, the underhood lamp, etc.
Clean any corrosion from the negative battery cable using a wire brush.

NOTE: Refer to FASTENER NOTICE in Cautions and Notices.

Connect the negative battery cable.
Tighten: Tighten the cable bolt to 15 N.m (11 lb ft).

Fig 1: Identifying Rear Battery Cover & Bolts

Courtesy of GENERAL MOTORS CORP.

Install the rear battery cover (2) and nuts (1).
Tighten: Tighten nuts to 10 N.m (89 lb in).
Lower the vehicle.
Reset the radio presets and theft codes.