Installation Procedure

WARNING: This page is about a different car, the 2003 Chevrolet SSR. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Lightly coat the MAP sensor seal with clean engine oil before installing the sensor.

Fig 1: Identifying MAP Sensor

Courtesy of GENERAL MOTORS CORP.

Install the MAP sensor (1). Push the MAP sensor down in order to engage the sensor into the retainer.

Fig 2: Engine Sight Shield

Courtesy of GENERAL MOTORS CORP.

Connect the MAP sensor electrical connector.
Install the intake manifold sight shield.
Tighten: Tighten the fasteners to 10 N.m (89 lb in).