FixVault
Home › Chevrolet › 2004 › SSR › Repair and Diagnosis › External Pages › Different car › Section 688 (Entertainment System) › Repair Instructions › Microphone Replacement - Radio Volume Compensator Interior › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Chevrolet SSR. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View of Microphone to Knee Bolster Electrical Connector
    GM1332733Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  1. Locate the microphone to the knee bolster.
  2. Install the screws securing the microphone to the knee bolster.

    Tighten:  Tighten the screws to 2 N.m (18 lb in).

  3. Connect the electrical connector.
  4. Install the right knee bolster. Refer to Knee Bolster Replacement - Right in Instrument Panel, Gages, and Console.
  5. Install the left knee bolster. Refer to Knee Bolster Replacement - Left in Instrument Panel, Gages, and Console.
About FixVault