Installation Procedure

WARNING: This page is about a different car, the 2003 Chevrolet SSR. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Seat Position Switch, Electrical Connector & Retaining Nuts

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to FASTENER NOTICE in Cautions and Notices.

Install the seat position switch (3) to the seat rail with 2 nuts (2).
Tighten: Tighten the seat position switch nuts to 4 N.m (35 lb in).
Connect the electrical connector (1) to the seat position switch (3).
Install the seat in the vehicle. Refer to Seat Replacement in Seats.