FixVault
Home › Chevrolet › 2004 › SSR › Repair and Diagnosis › External Pages › Different car › Section 709 (Body Front End) › Repair Instructions › Hood Latch Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Chevrolet SSR. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Expanded View of Hood Latch Cable
    GM1252564Courtesy of GENERAL MOTORS CORP.
  1. Connect the hood latch cable to the latch.
  2. Position the latch to the previously marked location on the mounting bracket.
    3. NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  3. Install the bolts which retain the latch to the mounting bracket.

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

  4. Inspect the latch for proper operation before closing the hood.
  5. Inspect the alignment of the latch to the hood striker. Adjust the latch, if necessary. Refer to Hood Latch Adjustment  .
  6. Install the engine splash shield. Refer to Splash Shield Replacement - Engine  .
About FixVault