FixVault
Home › Chevrolet › 2004 › SSR › Repair and Diagnosis › Transmission › Automatic Trans › Automatic Transmission - 4L60-E/4L65-E - Introduction, Service & Replacement › Repair Instructions › Transmission Extension Housing Assembly Replacement › Installation Procedure

Installation Procedure

    Fig 1: View Of Case Extension, Bolts & O-Ring Seal
    GM656358Courtesy of GENERAL MOTORS CORP.
  1. Install a new case extension O ring seal (3).
  2. Install the case extension (2).
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the case extension bolts (1).

    Tighten:  Tighten the case extension bolts (1) to 45 N.m (33 lb ft).

  4. Install the transmission mount. Refer to Transmission Mount Replacement (5.3L) .
  5. Install the propeller shaft. Refer toPropeller Shaft Replacement in Propeller Shaft.
  6. Remove the drain pan and the transmission jack.
  7. Lower the vehicle.
  8. Fill the transmission to the proper level with DEXRON® III transmission fluid. Refer to Transmission Fluid Checking Procedure .
About FixVault