FixVault
Home › Chevrolet › 2004 › Suburban K2500, 6.0 U › Repair and Diagnosis › External Pages › Different variant/trim › Section 4 (Engine Control System - 8.1L (Introduction)) › Repair Instructions › Fuel Tank Pressure Sensor Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Fuel Pressure Sensor
    GM1312086Courtesy of GENERAL MOTORS CORP.
  1. Lubricate the seal on the fuel pressure sensor.
  2. Press the fuel pressure sensor (1) into the line.
  3. Install the intermediate fuel/EVAP lines. Refer to Fuel Hose/Pipes Assembly Replacement (Front)  or Fuel Hose/Pipes Assembly Replacement (Intermediate) .
About FixVault