Installation Procedure

Install the boot (1) to the groove in the steering gear (3). Secure the boot to the steering gear with the boot band (2)

Fig 1: View Of Boot, Band & Steering Gear

Courtesy of GENERAL MOTORS CORP.

Apply chassis grease, GM P/N 12377985, or equivalent, to the inner tie rod (1).
Ensure the boot is not twisted, dented, or improperly folded.
Secure the boot (3) to the inner tie rod with the boot clip (2).
Install the outer tie rod. Refer to Rack and Pinion Outer Tie Rod End Replacement .
Lower the vehicle.

Fig 2: View Of Inner Tie Rod, Boot & Clip

Courtesy of GENERAL MOTORS CORP.