FixVault
Home › Chevrolet › 2004 › Tracker RWD › Repair and Diagnosis (Single Page) › Engine Performance › System › Engine Control System - 2.0L (Introduction) › Repair Instructions › Exhaust Gas Recirculation (EGR) Valve Replacement › Installation Procedure

Installation Procedure

  1. Install the EGR valve gasket (4).
  2. Install the EGR valve (2).
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install both retaining bolts (3).

    Tighten:  Tighten the bolts to 25 N.m (18 lb ft).

  4. Connect the EGR valve electrical connector.
    5. Fig 1: View Of EGR Valve, Gasket, Intake Manifold & Retaining Bolts
    GM419568Courtesy of GENERAL MOTORS CORP.
About FixVault