FixVault
Home › Chevrolet › 2004 › Tracker RWD › Repair and Diagnosis › Engine Performance › System › Engine Control System - 2.0L (Introduction) › Repair Instructions › Manifold Absolute Pressure (MAP) Sensor Replacement › Removal Procedure

Removal Procedure

  1. Disconnect the electrical connector (4) from the MAP sensor (1).
    2. Fig 1: View Of MAP Sensor & Electrical Connector
    GM455400Courtesy of GENERAL MOTORS CORP.
  2. Remove the 2 MAP sensor attaching bolts (1).
  3. Remove the MAP sensor (2) from the intake plenum.
    4. Fig 2: View Of MAP Sensor & Attaching Bolts
    GM470743Courtesy of GENERAL MOTORS CORP.
About FixVault