FixVault
Home › Chevrolet › 2004 › Tracker RWD › Repair and Diagnosis › Engine Performance › System › Engine Control System - 2.5L (LE8) (Introduction) › Repair Instructions › Crankshaft Position (CKP) Sensor Replacement › Removal Procedure

Removal Procedure

  1. Disconnect the electrical connector from the crankshaft position (CKP) sensor.
  2. Remove the bolt (1) and the sensor wire harness clip from the engine.
  3. Remove the bolt (3) securing the CKP sensor to the front engine cover.
    4. Fig 1: View Of Crankshaft Position Sensor & Bolts
    GM711807Courtesy of GENERAL MOTORS CORP.
  4. Remove the CKP sensor (3) with wire harness from the engine.
  5. Inspect the CKP sensor signal rotor for damaged or missing teeth through the CKP sensor opening.
    6. Fig 2: View Of Crankshaft Position Sensor
    GM711797Courtesy of GENERAL MOTORS CORP.
About FixVault