FixVault
Home › Chevrolet › 2004 › Venture Base, Van Cargo Extended › Repair and Diagnosis › Engine Performance › System › Engine Control System - 3.4L (Introduction) › Repair Instructions › Crankshaft Position (CKP) Sensor Replacement (CKP sensor A) › Removal Procedure

Removal Procedure

  1. Turn OFF the ignition.
    Fig 1: Identifying CKP Sensor (CKP Sensor A)
    GM14714Courtesy of GENERAL MOTORS CORP.
  2. Remove the serpentine drive belt from crankshaft pulley. Refer toDrive Belt Replacement in Engine Mechanical.
  3. Raise the vehicle on hoist. Refer to Lifting and Jacking the Vehicle in General Information
  4. Remove the crankshaft harmonic balancer. Refer to Crankshaft Balancer Replacement in Engine Mechanical.
  5. Note the routing of the CKP sensor harness before removal.
  6. Remove the harness retaining clip (3) with the bolt (4).
  7. Disconnect the CKP sensor electrical connector.
  8. Remove the sensor bolts (4).
  9. Remove the sensor.
About FixVault