FixVault
Home › Chevrolet › 2004 › Venture Base, Van Cargo Extended › Repair and Diagnosis › Steering › Steering Wheel & Steering Column › Repair Instructions › Steering Column Anchor Cable Replacement › Installation Procedure

Installation Procedure

  1. Properly route the steering column anchor cable.
  2. Install the anchor cable to the center console bracket stud.
    3. Fig 1: Locating Anchor Cable Nut
    GM545578Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the anchor cable nut to the center console bracket stud.

    Tighten:  Tighten the nut to 10 N.m (89 lb in).

  4. Install the anchor cable end to the steering column stud.
    5. Fig 2: Locating Steering Column Upper Nut
    GM545583Courtesy of GENERAL MOTORS CORP.
  5. Install the steering column nut. Refer to Steering Column Replacement .
  6. Install the center console. Refer to Console Replacement - Front Floor in Instrument Panel, Gages and Console.
  7. Install the knee bolster. Refer to Knee Bolster Replacement in Instrument Panel, Gages and Console.
About FixVault