FixVault
Home › Chevrolet › 2005 › Avalanche 2500 › Repair and Diagnosis › External Pages › Different car › Section 11 (Entertainment System) › Repair Instructions › Receiver Replacement - Digital Radio › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 GMC Sierra and 2005 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Digital Radio Receiver & Wire Connector
    GM854856Courtesy of GENERAL MOTORS CORP.
  1. Connect the coaxial cables.
  2. Connect the wire connector (1).
  3. Install the receiver and bracket assembly to the I/P.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the 2 retaining screws.

    Tighten:  Tighten the screws to 1.6 N.m (14 lb in).

  5. Install the right side junction block to the I/P. Refer to Instrument Panel Electrical Center or Junction Block Replacement - Right in Wiring Systems.
  6. Close the I/P compartment door.
  7. Perform the setup procedure for the digital radio receiver. Refer to Digital Radio Receiver Setup .
About FixVault