FixVault
Home › Chevrolet › 2005 › Avalanche 2500 › Repair and Diagnosis › External Pages › Different car › Section 20 (Engine Controls - 4.3L (Introduction)) › Repair Instructions › Fuel Level Sensor Replacement › Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2005 GMC Sierra and 2005 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Fuel Level Sensor (4.8L, 5.3L, & 6.0L)
    GM1306358Courtesy of GENERAL MOTORS CORP.
  1. Remove the sending unit. Refer to Fuel Sender Assembly Replacement .
  2. Disconnect the fuel pump electrical connector.
  3. Remove the fuel lever sensor electrical connector retaining clip.
  4. Disconnect the fuel level sensor electrical connector.
  5. Remove the fuel level sensor retaining clip.
  6. Remove the fuel level sensor (1).
About FixVault